Newly Created PASOE Application shows that it is IPv6 in OEM, but openedge.properties shows it actually using IPv4

When creating a PASOE application in OEM, the abl application shows that it us using IPv6 under ABL Application / Configuration / Network Environment / IP Version Radio Button. However, when investigating the openedge.properties, only IPv4 is referenced in the AppServer.SessMgr section. ipver is not referenced anywhere else in the properties file.

Was this article helpful?

Disclaimer

The origins of the information on this site may be internal or external to Progress Software Corporation (“Progress”). Progress Software Corporation makes all reasonable efforts to verify this information. However, the information provided is for your information only. Progress Software Corporation makes no explicit or implied claims to the validity of this information.

Any sample code provided on this site is not supported under any Progress support program or service. The sample code is provided on an "AS IS" basis. Progress makes no warranties, express or implied, and disclaims all implied warranties including, without limitation, the implied warranties of merchantability or of fitness for a particular purpose. The entire risk arising out of the use or performance of the sample code is borne by the user. In no event shall Progress, its employees, or anyone else involved in the creation, production, or delivery of the code be liable for any damages whatsoever (including, without limitation, damages for loss of business profits, business interruption, loss of business information, or other pecuniary loss) arising out of the use of or inability to use the sample code, even if Progress has been advised of the possibility of such damages.