Article Type: Solution

There are two primary causes to this error.

The first is using service instead of systemctl to start MarkLogic on some Linux distros.  The second is related to the Linux language settings.

Solutions

Below are the solutions for the causes mentioned in the preceding section.

Starting MarkLogic Service

On an Azure MarkLogic VM, as well as some more recent Linux distros, you must use systemctl, and not service to start MarkLogic. To start the service, use the following command:

• sudo systemctl start MarkLogic

Linux Language Settings

This issue occurs when the Linux Locale LANG setting is not set to UTF-8.  This can be accomplished by changing the value of LC_ALL to "en_US.UTF-8".  This should be done for the root user for default installations of MarkLogic.  To change the system wide locale settings, the /etc/locale.conf needs to be modified. This can be done using the localectl command.

• sudo localectl set-locale LANG=en_US.UTF-8

If MarkLogic is configured to run as a non-root user, then setting the locale can be done in the users environment.  Setting the value can be done using the $HOME/.i18n file.  If the file does not exist, please create it and ensure it has the following:

• export LANG="en_US.UTF-8"

If that does not resolve the issue in the user environment, then you may need to look at setting LC_CTYPE, or LC_ALL for the locale.

• LC_CTYPE will override the character set part of the LANG setting, but will not change other locale settings.
• LC_ALL will override both LC_CTYPE and all locale configurations of the LANG setting.

References to Other Documentation:

• https://access.redhat.com/documentation/en-us/red_hat_enterprise_linux/7/html/system_administrators_guide/ch-keyboard_configuration

• https://access.redhat.com/solutions/974273

• https://www.unix.com/man-page/centos/1/localectl/

• http://man7.org/linux/man-pages/man1/locale.1.html