[icf-dev] ENABLE OR DISABLE DYNCOMBO IN SUPER PROCEDURE OF DYNVIEWER - Forum - OpenEdge Development - Progress Community

[icf-dev] ENABLE OR DISABLE DYNCOMBO IN SUPER PROCEDURE OF DYNVIEWER

 Forum

[icf-dev] ENABLE OR DISABLE DYNCOMBO IN SUPER PROCEDURE OF DYNVIEWER

  • How can I enable or disable a dyncombo in a super procedure of a

    dynviewer?

    In the procedure initializeObject I can retrieve the handle of the

    field linked to the dyncombo. But how can change the senisitive

    attribute of the linked dynamic combo?

    Kind regards,

    Yves Van Eester

    To unsubscribe, e-mail: dev-unsubscribe@icf.possenet.org

    For additional commands, e-mail: dev-help@icf.possenet.org

  • Yves,

    You can run EnableField and DisableField in the handle of the combo.

    -Original Message-

    From: Yves Van Eester

    Sent: 27 February 2003 15:49

    To: dev@icf.possenet.org

    Subject: ENABLE OR DISABLE DYNCOMBO IN SUPER PROCEDURE OF

    DYNVIEWER

    How can I enable or disable a dyncombo in a super procedure of a

    dynviewer?

    In the procedure initializeObject I can retrieve the handle of the

    field linked to the dyncombo. But how can change the senisitive

    attribute of the linked dynamic combo?

    Kind regards,

    Yves Van Eester

    To unsubscribe, e-mail: dev-unsubscribe@icf.possenet.org

    For additional commands, e-mail: dev-help@icf.possenet.org

    To unsubscribe, e-mail: dev-unsubscribe@icf.possenet.org

    For additional commands, e-mail: dev-help@icf.possenet.org